This is an old revision of the document!

If your machine engraved a mirror or inverted image. If you click left on the computer software, the machine go right.

Your machine's axis direction is wrong. This is a easy problem.


Let's find out which axis is in the opposite direction.

Move the axis by software, for example Engraver Master.

If you click right (X+), the machine goes left. That's the X axis.

If you click up (Z+), the machine goes down. That's the Z axis.

If you click back (y+), the machine goes front. That's the Y axis.


Open the Device Settings page on the Engraver Master. You can easy solve the problem by enable or disable the Reverse N Axis options.

On Bachin Master software, it is a similar operation.

  • how_to_invert_direction.1531353319.txt.gz
  • Last modified: 2018/07/11 23:55
  • by ljx